Next morning, we continue cut the polypipe joints because we not able to finish it yesterday. A curve have been mark on the polypipe for the workshop's worker to cut it with machine (to make work easier)
mark a curve before cut with machine
the worker that help us to cut
cutting process
after that, warm up the polypipe with the fire
then immediately clip it with two pieces of flat wood
to make the surface flat
polish to make the side smooth
done~
marking on the middle for the screw's hole
the screw's hole will on the middle of the 'X' mark
machine that used to screw the hole
hit it with wood hammer to make it fit into the bamboo
some was quite lose, problem solve with inserting some
bamboo remainder to tighten it
Finally done our parts!!! HOORAYYY~
No comments:
Post a Comment